GARVEE GARVEE-Axis Power Feed for Power Milling Machines, Adjustable Speed Table Milling Machine Power Feed, Perfect for Bridgeport and Similar Knee-Type Mills, 450 LB Torque, 110V, 0-200PRM

Required some additional work to mount. I had to make a special bearing race 1/2 inch longer than supplied and a shim for the dial nut. Other than that it fit and is working fine on my ZX5051 Chinese mill simular to the Grizzly mini mill.

Required some additional work to mount. I had to make a special bearing race 1/2 inch longer than supplied and a shim for the dial nut. Other than that it fit and is working fine on my ZX5051 Chinese mill simular to the Grizzly mini mill.

Works great, feeds consistently. Wish it had a feed speed rate display.

Works great, feeds consistently. Wish it had a feed speed rate display.

Removing the old one and getting the new one in place was perfect, even for an upgrade!

Replaced the Grizzly unit on my milling machine that lasted about 20 years. While it fit and does the job, I had to machine a spacer to cover a small gap between the unit and the bed. Not a problem as all mills are slightly different,Only complaint is the difficulty to run the unit at a slow speed. Speed adjuster seems to favor high speeds. Very slow speeds are hard to set.

Replaced the Grizzly unit on my milling machine that lasted about 20 years. While it fit and does the job, I had to machine a spacer to cover a small gap between the unit and the bed. Not a problem as all mills are slightly different,Only complaint is the difficulty to run the unit at a slow speed. Speed adjuster seems to favor high speeds. Very slow speeds are hard to set.

I used this for a Rug Fu style round post milling machine. It wasnt designed for this machine, so it took some creativity to make it work. Quality seems very good. As long as you have some common sense and mechanical skills, you can get this to work on most any mill. Would buy again.